Thursday, March 7, 2013

Home » » HOW TO ASSEMBLE OR INSTALLING THE RADIO FM

HOW TO ASSEMBLE OR INSTALLING THE RADIO FM


I am often asked to make FM radio or adding to Sepeaker Amplifier and other active or
How to assemble? follow the steps - steps to assemble the following FM radio

To assemble the FM STEREO RADIO which should prepare the following:
1. FM STEREO TUNER KIT
2. KIT STEREO TONE CONTROL
3. OCL POWER KIT STEREO
4. TRANSFORMER 5 AMPERE CT
5. BOX


Step-by-Step Assemble stereo FM radio

1. Solder wires to the transformer electric 0 - 220V and barely Power Switch on / off
2. Connect the output transformer (18V-0-18V) to the PCB Power Supply
3. Connect the Power Supply output gets STEREO PCB Power OCL. Attention: Jaqan to reverse polarity if reverse OCL STEREO POWER KIT can be damaged!!!
4. Connect the output SPK on OCL STEREO POWER KIT PCB to Terminal Sepeaker. Then try to plug the power cord into 220V electricity and the switch is on and the touch input section on the PCB KIT STEREO POWER OCL. If you hear a loud noise on the SPK then reinforced properly and continue the next step.
5.

1. Connect the 12V DC input (+, -) on KIT FM STEREO TUNER to PCB POWER SUPPLY. should give additional regulator IC 7812, because the voltage is needed KIT FM STEREO TUNER is 12V
2. Connect the output (L & R) at KIT FM STEREO TUNER input to the PCB KIT STEREO TONE CONTROL
3. Connect the output (L & R) on the PCB KIT TONE CONTROL to input (L & R) on the PCB KIT STEREO POWER OCL
4. Connect the 12V DC input (+, -) on the PCB to PCB KIT TONE CONTROL POWER SUPPLY
5. solder and plug it into the antenna input on the antenna TUNER
6. Thorough kembalil is correct and no upside, especially the DC 12V.
7. ON the device and search the broadcast, if there is a signal or broadcast mak green light comes on and if the transmitter Stereo then the red light comes on also

GOOD TRY LUCK!!!
Share this Artickel :

No comments:

Post a Comment